System self-test

After you have switched on the ignition, the system carries out a self-diagnosis.

WARNING
A malfunction in the system has been detected if one of the following conditions occurs:

 - the indicator lamp in the SOS button does not light up during the system selfdiagnosis.

 - the indicator lamp in the Roadside Roadside Assistance button does not light up during the system self-diagnosis.

 - The indicator lamp in the information information button does not light up during selfdiagnosis of the system.

 - the indicator lamp in the SOS button, Roadside Assistance button or information button continues to be lit red information button continues to be lit red after the system self-diagnosis.

 - The Tele Aid Inoperative or Tele Aid Not Activated message appears in the multifunction display after the system selftest.

If a malfunction is indicated as outlined above, the system may not operate as expected. In the event of an emergency, assistance must be summoned by other means.

Have the system checked at the nearest authorized Mercedes-Benz Center or contact the following service hotlines:

 - USA: Mercedes-Benz Customer Assistance Center under 1-800-FOR-MERCedes(1-800-367-6372) or 1-888-990-9007

 - Canada: Customer Service at 1-888-923-83

    See also:

    Change of direction
    Introduction Changes of direction have three phases: • preparation phase • announcement phase • change-of-direction phase Preparation phase COMAND prepares you for the upcoming change of ...

    Tire size designation, load-bearing capacity and speed rating
    1. Tire width 2. Nominal aspect ratio in % 3. Tire code 4. Rim diameter 5. Load bearing index 6. Speed rating Tire data is vehicle-specific and may deviate from the data in th ...

    Displays in the COMAND display
    WARNING Use of rear view camera can be dangerous if you are color-blind or have impaired color vision. Only use rear view camera if you can see and distinguish all colored guidelines shown by ...