Adding DEF
WARNING
Make sure
- DEF does not come into contact with skin,
eyes, or clothing
- to keep DEF out of the reach of children
If you and/or others have come into contact
with DEF:
- If DEF has gotten into contact with eyes, flush with plenty of water immediately and seek medical help.
- Clean affected skin immediately with plenty of water.
- If DEF was swallowed, rinse mouth immediately with plenty of water and drink plenty of water. Consult a physician.
WARNING
If you open the DEF tank cap at high
temperatures, ammonia vapors can be
released.
Ammonia vapors have a pungent odor and are particularly irritating to:
- skin
- mucous membranes
- eyes
You may experience a burning sensation in your eyes, nose and throat, as well as coughing and watering of the eyes.
Do not inhale any ammonia vapors that may be released. Only refill the DEF tank in well ventilated areas.
Only use DEF that complies with ISO 22241. Do not add any special additives to DEF and do not thin DEF with water. This could destroy the BlueTEC exhaust gas aftertreatment.
If the outside temperature is lower than -11 °C, damage may occur when topping up.
If DEF is frozen and there is an active warning indicator, topping up may not be possible.
Park the vehicle in a warmer place, e.g. in a garage, until DEF has become fluid again.
Filling is then possible again. Alternatively, have the DEF tank refilled at a qualified specialist workshop.
Rinse surfaces that have come into contact with DEF immediately with water or remove DEF using a damp cloth and cold water. If the DEF has already crystallized, use a sponge and cold water to clean it. DEF residues crystallize after time and contaminate the affected surfaces.
DEF is not a fuel additive and must not be added to the fuel tank. If DEF is added to the fuel tank, this can lead to engine damage.
If you are adding between maintenance intervals, add approximately 1 gallon (3.8 l) of DEF to the DEF tank. One gallon (3.8 l) of DEF is approximately 2 DEF refill bottles.
Then, have the DEF supply checked and filled completely if necessary. For this purpose, Mercedes-Benz recommends a qualified specialist workshop.
Further information on DEF.
The DEF filler neck is under the trunk floor.
•► Switch off the ignition.
•► Open the trunk.
•► Lift up the trunk floor
•► Turn DEF cap 1 counter-clockwise and remove it.
•► Turn DEF filler cap 2 counter-clockwise and open it.
Filler cap 2 is secured with a plastic strap.
•► Unscrew the covering cap from DEF refill bottle 3.
•► Place DEF refill bottle 3 on the filler neck as shown and screw on clockwise handtight.
Only screw on the DEF refill bottle handtight.
It could otherwise be damaged.
•► Press DEF refill bottle 3 down.
The DEF tank is filled. This may take up to one minute.
If the DEF refill bottle is no longer pressed down, the filling process stops and the partially emptied bottle can be removed.
•► Release DEF refill bottle 3.
•► Turn DEF refill bottle 3 counter-clockwise
and remove it.
•► Place DEF filler cap 2 on the filler neck and
turn it clockwise.
•► Insert DEF cap 1 as shown and turn it
clockwise as far as it will go.
•► Fold the trunk floor down.
•► Close the trunk lid.
•► Drive at a speed above 10 mph (16 km/h).
The Check Additive See Operator's Manual message goes out after approximately one minute.
If the Check Additive See Operator's Manual message remains shown in the multifunction display, add an additional bottle of DEF.
Then, have the DEF supply checked at a qualified specialist workshop and completely refilled if necessary.
See also:
Notes on audio AUX mode
You can connect an external audio source
(AUX) to COMAND. The socket for this is
located in the glove box.
If COMAND is equipped with a Media
Interface, external audio sources are
connected u ...
Important safety notes
WARNING
In order to help prevent spilling liquids on
vehicle occupants and/or vehicle equipment,
only use containers that fit into the cup
holder. Use lids on open containers and do
not fill ...
Cleaning the exhaust tail pipes
Impurities combined with the effects of road
grit and corrosive environmental factors may
cause flash rust to form on the surface. You
can restore the original shine of the exhaust
tail pipe b ...