Brakes: with Hill-Start Assist and brake drying function
With the ADAPTIVE BRAKE, the new CLS offers an innovative braking system incorporating additional assistance functions for even greater comfort and safety. One example of this is the practical HOLD function: after braking to a standstill, briefly pressing the brake pedal a little further is all that is required to activate this function. The car is then held by the brakes, even if the driver's foot comes off the brake pedal. The HOLD function is deactivated automatically when the car moves off.
If the driver's foot moves abruptly from the accelerator to the brake pedal before an emergency stop, the brake system increases the pressure in the brake lines and brings the pads into contact with the brake discs so that maximum braking power is available as soon as the driver hits the brake pedal. This priming of the brakes allows the system to assist the standard-fit Brake Assist system.
ADAPTIVE BRAKE also has safety benefits in the wet: the system briefly applies the brakes at regular intervals to wipe the film of water from the brake discs and ensure that the brakes are able to perform at their peak. The finely metered brake pulses are imperceptible to the driver. This automatic brake drying function is always activated when the windscreen wipers have been operating for a certain length of time.
Finally, ADAPTIVE BRAKE assists the driver when starting on an uphill slope. When the sensors detect that the Coupé is stopped on an uphill slope, Hill-Start Assist is activated automatically, briefly holding the brake pressure at a constant level so as to prevent the car from rolling backwards.
See also:
On-board diagnostic interface
WARNING
If you connect equipment to the on-board
diagnostics interface, it can affect the
operation of the vehicle systems. This can
impair the operating safety of your vehicle
while driving ...
Belt warning for the driver and front passenger
Regardless of whether the driver and front
passenger have fastened their seat belts
already, the seat belt warning lamp
lights up for 6 seconds after every engine
start. It then goes out if t ...
System self-test
The indicator lamp illuminates when
you:
turn the SmartKey to position 1 or 2 in the ignition lock
on vehicles with KEYLESS-GO, press the Start/Stop button once or twice
If an adult occupa ...