ATA (Anti-Theft Alarm system)
A visual and audible alarm is triggered if the alarm system is armed and you open:
• a door
• the vehicle with the mechanical key
• the tailgate
• the hood
The alarm is not switched off, even if you close the open door that has triggered it, for example.
If the alarm stays on for more than 30 seconds, the emergency call system mbrace (USA only) or TELE AID (Canada only) initiates a call to the Customer Assistance Center automatically. The emergency call system initiates the call provided that:
• you have subscribed to the mbrace/TELE
AID service.
• the mbrace/TELE AID service has been
activated properly.
• the required mobile phone, power supply
and GPS are available.
► To arm: lock the vehicle with the SmartKey or KEYLESS-GO.
Indicator lamp 1 flashes. The alarm system is armed after approximately 10 seconds.
► To deactivate: unlock the vehicle with the SmartKey or KEYLESS-GO.
X To stop the alarm using the SmartKey:
insert the SmartKey into the ignition lock.
The alarm is switched off.
or
► Press the
button on the
SmartKey.
The alarm is switched off.
► To stop the alarm using KEYLESS-GO:
grasp the outside door handle. The SmartKey must be outside the vehicle.
The alarm is switched off.
or
► Press the Start/Stop button on the
dashboard. The SmartKey must be inside
the vehicle.
The alarm is switched off.
See also:
Blind Spot Assist
Important safety notes
Blind Spot Assist uses a radar sensor system
to monitor the areas on both sides of your
vehicle. It supports you from speeds of
approximately 20 mph (30 km/h). A warning ...
EBD (electronic brake force distribution)
Observe the "Important safety notes" section ().
EBD monitors and controls the brake pressure on the rear wheels to improve driving
stability while braking.
WARNING
If EBD has m ...
Cleaning the paintwork
Scratches, corrosive deposits, areas affected
by corrosion and damage caused by
inadequate care cannot always be completely
repaired. In such cases, visit a qualified
specialist workshop, e.g. ...