Activating the rear view camera
- Make sure that the SmartKey is in position 2 in the ignition lock.
- Make sure that the "rear view camera" function is selected in COMAND (see the separate operating instructions for COMAND).
- Engage reverse gear. The area behind the vehicle is shown in the COMAND display with guide lines.
See also:
High-beam headlamps
To switch on the high-beam
headlamps: turn the SmartKey in the ignition lock to position 2 or start
the engine.
Turn the light switch to
or
or
.
Press the combination switch beyond
the ...
Calling up a stored parking position setting
Turn the SmartKey to position
2 in the
ignition lock.
Adjust the exterior mirror on the
frontpassenger
side with the corresponding
button.
Engage reverse gear.
The exterior mirror on t ...
Vehicle identification number (VIN)
The vehicle identification number (VIN) can
be found in the following locations:
- on the vehicle identification plate
- at the lower edge of the windshield
In addition to being stamped on the ve ...