Problems with the windshield wipers

The windshield wipers are obstructed

Leaves or snow, for example, may be obstructing the windshield wiper movement. The wiper motor has been deactivated.

  • For safety reasons, you should remove the SmartKey from the ignition lock.

or

  • Switch off the engine using the Start/Stop button and open the driver's door.
  • Remove the cause of the obstruction.
  • Switch the windshield wipers back on.

The windshield wipers are inoperative

The windshield wiper drive is malfunctioning.

  • Select another wiper speed on the combination switch.
  • Have the windshield wipers checked at a qualified specialist workshop.

The spray nozzles are misaligned

The windshield washer fluid from the spray nozzles no longer hits the center of the windshield. The spray nozzles are misaligned.

  • Have the spray nozzles adjusted at a qualified specialist workshop.
    See also:

    Cleaning the seat belts
    – Use clean, lukewarm water and soap solution. Do not clean the seat belts using chemical cleaning agents. Do not dry the seat belts by warming them above 176 °F (80 °C) or placing them ...

    Side impact air bags
    WARNING The pressure sensors for side impact air bag control are located in the doors. Do not modify any components of the doors or door trim panels including, for example, the addition o ...

    Switching the front climate control on/off using the front control panel
    Turn the SmartKey to position 2 in the ignition lock. To activate: press the rocker switch up or down. The indicator lamp in the rocker switch goes out. The previously selected settings ...