Resetting the panorama roof with power tilt/sliding panel and the roller sunblinds
Reset the panorama roof with power tilt/ sliding panel and the roller sunblinds if the panorama roof with power tilt/sliding panel or the roller sunblinds do not move smoothly.
- Turn the SmartKey to position 1 or 2 in the ignition lock.
- Press the switch to the point of resistance in the direction of arrow 2 and hold it until the panorama roof with power tilt/sliding panel has opened about 4 in (10 cm).
- Pull the switch repeatedly to the point of resistance in the direction of arrow 3 until the panorama roof with power tilt/ sliding panel is fully closed.
- Keep the switch pulled for an additional second.
- Press the switch to the point of resistance in the direction of arrow 2 and hold it until the sunblinds have opened about 4 in (10 cm).
- Pull the switch repeatedly to the point of resistance in the direction of arrow 3 until the roller sunblinds are fully closed.
- Keep the switch pulled for an additional second.
- Make sure that the panorama roof with power tilt/sliding panel and the roller sunblinds can be fully opened and closed again ().
- If this is not the case, repeat the steps above again.
If the panorama roof with power tilt/ sliding panel and the roller sunblind cannot be fully opened or closed after resetting, contact a qualified specialist workshop.
See also:
Heavy and light loads
WARNING
Depressing the brake pedal constantly results
in excessive and premature wear to the brake
pads.
It may also cause the brakes to overheat,
seriously impairing their effectiveness. ...
Fuse box in the engine compartment
Make sure that the windshield wipers are turned off.
WARNING
Make sure that the windshield wipers are switched off and that
the SmartKey is removed from the ignition lock before you open ...
SmartKey
SmartKey
0 To remove the SmartKey
Vehicles with automatic transmission: shift the transmission to position P
1 Power supply for some consumers, such as the windshield wipers
2 Ignition (power su ...