Automatic car wash
WARNING
Braking efficiency is reduced after washing
the vehicle. This could cause an accident. For
this reason, you must drive particularly
carefully after washing the vehicle until the
brakes have dried.
WARNING
The vehicle is braked when the HOLD function
or DISTRONIC PLUS is activated. Therefore,
deactivate the HOLD function and DISTRONIC
PLUS before the vehicle is washed in an
automatic car wash.
You can wash the vehicle in an automatic car wash from the very start.
Never clean your vehicle in a Touchless Automatic Car Wash as these use special cleaning agents. These cleaning agents can damage the paintwork or plastic parts.
If the vehicle is very dirty, pre-wash it before cleaning it in an automatic car wash.
In car washes with a towing mechanism, make sure that the automatic transmission is in transmission position N, otherwise the vehicle could be damaged.
• Vehicles with a SmartKey:
Do not remove the SmartKey from the ignition lock. Do not open the driver's door or front-passenger door when the engine is switched off. Otherwise, the automatic transmission selects park position P automatically and locks the wheels. You can prevent this by shifting the automatic transmission to N beforehand.
RVehicles with KEYLESS-GO:
Do not open the driver's door or frontpassenger door when the engine is switched off. Otherwise, the automatic transmission selects park position P automatically and locks the wheels.
Observe the following to make sure that the automatic transmission stays in position N:
Make sure the vehicle is stationary and the ignition is switched off.
Turn the SmartKey to position 2 in the ignition lock.
Use the SmartKey instead of the Start/Stop button on vehicles with KEYLESS-GO.
Depress and hold the brake pedal.
Shift the automatic transmission to position N.
Release the brake pedal.
Release the electric parking brake.
Switch off the ignition and leave the SmartKey in the ignition lock.
Make sure that:
• the side windows and the sliding sunroof
are fully closed.
• the ventilation/heating is switched off
(the OFF button has been pressed).
• the windshield wiper switch is in position
0.
Otherwise, the vehicle might be damaged.
After using an automatic car wash, wipe off wax from the windshield and the wiper blades. This will prevent smears and reduce wiping noises caused by residue on the windshield.
See also:
General notes
WARNING
All categories of messages contain important information which should be taken
note of and, where a malfunction is indicated, addressed as soon as possible at
an authorized Mercedes- ...
Vehicle data, GL 450
The data stated here refers specifically to a
vehicle with standard equipment. Consult an
authorized Mercedes-Benz Center for the
data for all vehicle variants and trim levels.
...
Opening
You can open the tailgate automatically using the SmartKey or the handle in the
tailgate.
Open or close the tailgate fully using the automatic function if you have stopped
the tailgate in an inte ...