Dialing a number from the phone book
You can use the mobile phone to enter new telephone numbers into the phone book (see COMAND). If your mobile phone is operational, you can select and dial a number from the phone book at any time.
When you establish a Bluetooth® connection to COMAND, COMAND reads in the phone book of the mobile phone. This can take some time.
While the on-board computer reads in the SIM card:
• you can dial a telephone number from the redial list (Calls dialed list).
• you can dial a telephone number from the telephone book stored in COMAND.
• the multifunction display shows the Reading data... display message below the phone book entries.
When the multifunction display shows the Updating data... display message, COMAND has finished importing data. The multifunction display then shows all the phone book entries in COMAND and the mobile phone.
Press the
or
button on the
steering wheel to select the Telephone
menu.
Press the
,
or
button to call
up the phone book.
Press the
or
button to select the
desired name.
To scroll rapidly, press and hold the
or
button for longer than one
second.
After skipping eight entries, the rapid scroll speeds up.
Rapid scrolling stops when you release the button or reach the end of the list.
If only one telephone number is stored
for a name: press the
or
button
to start dialing.
or
If there is more than one number for a
particular name: press the
or
button to display the numbers.
Press the
or
button to select the
number you want to dial.
Press the
or
button to start
dialing.
or
If you do not want to make a call: press
the
or
button.
See also:
Displaying the range and current fuel consumption
Press the or
button on the steering wheel to
select the Trip menu.
Press the or
button to select current fuel consumption
and approximate range.
Current fuel consumption
A ...
Changing a wheel
Flat tire
The "Roadside Assistance" section contains information and notes
on how to deal with a flat tire. It also provides
instructions on changing a wheel or mounting
the spare wheel/ ...
Initiating point of interest entry
To activate navigation mode: press the
function button once or twice.
To show the menu: press
the COMAND
controller.
Select Destination in the navigation
system menu bar by turning
...