Switching the city model on/off

When the city model is switched on, the map shows buildings as 3D models.

map" map orientation. The city model is only shown in the "3D map" map orientation.
It is available for map scales 50 m and 100 m.
The data required for displaying buildings is not available for all cities.

the COMAND To show the menu: press the COMAND the COMAND controller.

sliding  and turning Select Navi in the main function bar by sliding the COMAND and turning the COMAND the COMAND controller and press Select City (3D) and press to confirm.

to confirm. Select City (3D) and press to confirm. to confirm.

Depending on the previous state, switch the option on . or off .

1 Hills

1 Hills
2 Buildings
3 Important buildings

    See also:

    Setting the rear-compartment side air vents
    These rear-compartment side air vents are only available if your vehicle has 3-zone automatic climate control. 1 B-pillar air vent 2 Thumbwheel for B-pillar air vent - To open/close: turn thu ...

    The windshield wipers are obstructed
    Leaves or snow, for example, may be obstructing the windshield wiper movement. The wiper motor has been deactivated. For safety reasons, you should remove the SmartKey from the ignition lock. ...

    Limited Warranty
    Follow the instructions in this manual about the proper operation of your vehicle as well as about possible vehicle damage. Damage to your vehicle that arises from culpable contraventions agai ...