Deleting a destination or the home address from the destination memory
To activate navigation mode: press the function button once or twice.
To show the menu: press the COMAND controller.
Select Destination in the navigation system menu bar by turning the COMAND controller and press to confirm.
Select From Memory and press to confirm.
You will see the destination memory list either with the character bar (option 1) or as a selection list (option 2).
Option 1: destination memory list with character bar: proceed as described in the "Entering characters using the character bar" section.
Option 2: destination memory list as selection list: select a destination by turning the COMAND controller and press to confirm.
You see the address data of the selected entry.
Select Delete and press to confirm.
A prompt appears asking whether you wish to delete the destination.
Select Yes or No and press to confirm.
If you select Yes, COMAND deletes the destination. You will see a message to this effect.
If you select No, the process is aborted.
If the navigable address data for the destination being deleted is also assigned to an address book entry, COMAND will also delete this data from there. If the corresponding address book entry does not contain any further data, such as telephone numbers, COMAND deletes the entire address book entry.
See also:
High-beam flasher
•► To switch on: turn the SmartKey in the
ignition lock to position 1 or 2 or start the
engine.
•► Pull the combination switch in the direction
of arrow 3. ...
Making adjustments in 5 mph (Canada:10 km/h) increments
► Briefly press the cruise control lever
beyond the pressure point, up 1 for a
higher speed or down 2 for a lower speed.
The last speed stored is increased or
reduced. ...
Heavy and light loads
WARNING
Depressing the brake pedal constantly results
in excessive and premature wear to the brake
pads.
It may also cause the brakes to overheat,
seriously impairing their effectiveness. ...