Remote control
Overview
1 To switch the screen on/off
2 To switch the button lighting on/off
3 To select the screen for remote control operation (COMAND, SPLITVIEW, L REAR
and REAR R can be selected)
4 To select a menu or menu item
5 To confirm a selection or setting
6 To switch sound on/off (for corded headphones)
7 To adjust the volume (for corded headphones)
8 To skip; fast-forward/fast-rewind
9 To select a track; direct entry
10 To exit a menu (back)
Selecting the screen for the remote control
You can use the remote control to operate one of the two rear screens at a time. To do so, you must switch the remote control to the desired screen.
To select the left-hand screen: turn
thumbwheel 3 until "L REAR" is
highlighted in the window.
To select the right-hand screen: turn
thumbwheel 3 until "REAR R" is
highlighted in the window.
Switching the screen on/off
If the SmartKey in the ignition lock is in position 0 or 1 or if the SmartKey is not in the ignition lock, the rear screens will switch off after 30 minutes. Before the screens switch off, they show a message to this effect.
You can switch the screens back on.
However, this will discharge the starter battery.
Point the remote control at the rearcompartment
screen which has been
selected for remote operation.
Press button 1 on the remote control.
The respective rear screen switches on or
off.
You can only switch the screens on using the remote control if the ignition is switched on.
Switching the button lighting on/off
Press button 2 on the remote control.
Depending on the previous status, the
button lighting is switched on or off.
If you do not use the remote control for about 15 seconds, the button lighting switches off automatically.
Switching the sound on/off (corded headphones only)
Press button 6 on the remote control.
The sound is switched on/off.
Selecting a menu/menu item and confirming your selection
Press the buttons to select the menu/menu item and press the button to confirm.
See also:
Not Crossing Over
From Honda to BMW, the handbook on wagon styling evidently calls for anything
but a wagon — which leads to sleek, quasi-crossover profiles that lead to
minimal cargo room and even worse blind spot ...
Removing a wheel
Unscrew the uppermost wheel bolt
completely.
Screw alignment bolt 1 into the thread
instead of the wheel bolt.
Unscrew the remaining wheel bolts fully.
Do not place wheel bolts in sand ...
Changing the battery
You require a CR 2025 3 V cell battery.
- Take the mechanical key out of the
SmartKey.
- Press mechanical key 2 into the opening
in the SmartKey in the direction of the
arrow until battery t ...