Example of operation
Initial situation
You would like to switch from the vehicle
function to the radio function and select a
station from the station list, for example.
The following operating example describes
how to:
• call up the audio function
• switch on radio mode
• set a station.
Calling up the audio function
Select Audio in the main function bar by
sliding
and turning
the COMAND
controller and press
to confirm.
The basic display of the current audio
operating mode, e.g. audio CD, appears.
Switching to radio mode
Option 1
Press the
function button. The
radio display appears.
Repeated pressing of this function button
switches between radio and the most
recently active audio source.
Option 2
Select Audio again by sliding
the
COMAND controller and press
to
confirm.
The Audio menu appears.
1 Current audio operating mode
2 Main function bar
3 Audio menu
Press
the COMAND controller
and
confirm Radio.
The radio basic display appears with the
waveband last selected.
To set the station: if the display/selection
window is activated in the radio display,
turn
or slide
COMAND
controller.
See also:
Folding the cargo compartment floor up
► Press release handle 2 in the direction
of
the arrow.
► Lift cargo compartment floor 1 up by
release handle 2.
► Fold out hook 3 on the underside of the
cargo compartmen ...
Turn signal lamps/side marker lamps
Switch off the lights.
Open the hood.
Remove the headlamp cover ().
Left-hand headlamp: detach the washer fluid reservoir ().
Turn bulb holder 1 or 2 counterclockwise and pull it out.
W ...
Deactivating/activating ESP®
Observe the "Important safety
notes"
section.
WARNING
ESP® should not be deactivated during
normal driving other than in the
circumstances described below. Disabling
the system ...