Using KEYLESS-GO
The KEYLESS-GO key must be outside the vehicle. All the doors must be closed.
Touch recessed sensor surface 1 on the door handle until the side windows and the sliding sunroof or the panorama roof with power tilt/sliding panel are fully closed.
Make sure you only touch recessed sensor surface 1.
Make sure that all the side windows and the sliding sunroof or panorama roof with power tilt/sliding panel are closed.
To interrupt convenience closing: release recessed sensor surface 1 on the door handle.
On vehicles with roller sunblinds:
Touch the recessed sensor surface on the
door handle again until the roller sunblinds
close.
To interrupt the roller sunblind closing
procedure: pull the exterior door handle
and hold it firmly.
Resetting the side windows
You must reset each side window if:
• a side window cannot be closed
automatically
• a side window opens again slightly after
being closed manually
Close all the doors.
Turn the SmartKey to position 1 or 2 in the
ignition lock.
Pull the corresponding switch on the door
control panel until the side window is
completely closed.
Hold the switch for an additional second.
If the side window opens again slightly:
Immediately pull the corresponding switch
on the door control panel until the side
window is completely closed.
Hold the switch for an additional second.
If the corresponding side window remains
closed after the button has been released,
the side window has been reset correctly.
If this is not the case, repeat the steps
above again.
See also:
Removing and installing the cover in the
front wheel arch
You must remove the cover from the front
wheel housing before you can change the
front bulbs.
- To remove: switch off the lights.
- Turn the front wheels inwards.
- Slide up cover 1 and ...
Recommended tire pressure
The recommended tire pressure applies to
the tires mounted at the factory.
The Tire and Loading Information placard
contains the recommended tire pressures for
cold tires on a fully loaded vehi ...
Range of the sensors
General notes
The sensors must be free of dirt, ice and
slush; otherwise they may not function
correctly. Clean the sensors regularly, taking
care not to scratch or damage them.
Side view
To ...