Changing gear

The automatic transmission shifts to the individual gears automatically when it is in transmission position D. This automatic gearshifting behavior is determined by:
- a possible limitation of the shift range
- the position of the accelerator pedal
- the road speed

    See also:

    Belt warning for the driver and front passenger
    Regardless of whether the driver and front passenger have fastened their seat belts already, the seat belt warning lamp lights up for 6 seconds after every engine start. It then goes out if t ...

    Service and literature
    Your vehicle is covered under the terms of the warranties printed in the Service and Warranty Information booklet. Your authorized Mercedes-Benz Center will exchange or repair any defective pa ...

    Cargo tie-down rings
    Observe the following notes on securing loads: secure the load using the cargo tie down rings. do not use elastic straps or nets to secure a load, as these are only intended as an anti-slip p ...