Activating the HOLD function
•► Make sure that the activation conditions are met.
•► Depress the brake pedal.
•► Quickly depress the brake pedal further until HOLD display 1 appears in the multifunction display.
The HOLD function is activated. You can release the brake pedal.
If depressing the brake pedal the first time does not activate the HOLD function, wait briefly and then try again.
WARNING
The vehicle's brakes are applied when the
HOLD function is activated. For this reason,
deactivate the HOLD function if the vehicle is
to be set in motion by other means (e.g. in a
car wash or by towing).
See also:
Conditions
On the mobile phone
For telephony via COMAND's Bluetooth®
interface, a Bluetooth®-capable mobile
phone is required.
Not all mobile phones available on the
market are equally suitable. More de ...
Introduction
You can establish a Bluetooth® connection to
COMAND.
WARNING
A driver's attention to the road must always
be his/her primary focus when driving. For
your safety and the safety of others, we ...
Information about driving abroad
Converting to symmetrical low beam when driving abroad: switch the headlamps
to symmetrical low beam in countries in which traffic drives on the opposite side
of the road to the country where the ...