Deactivating/activating ESP® (except AMG vehicles)

WARNING
ESP® should not be deactivated during normal driving other than in the circumstances described below. Disabling the system will reduce vehicle stability in driving maneuvers.

Do not deactivate ESP® when the emergency or spare wheel is mounted.

ESP® is activated automatically when the engine is started.

It may be best to deactivate ESP® in the following situations:
- when using snow chains
- in deep snow
- on sand or gravel

WARNING
Switch on ESP® immediately if one of the previously stated conditions is no longer met.

Otherwise, ESP® cannot stabilize the vehicle if it begins to lurch or when a wheel spins.

If you deactivate ESP®:
- ESP® no longer improves driving stability.
- the engine's torque is no longer limited and the drive wheels can spin. The spinning of the wheels results in a cutting action, which provides better grip.
- traction control is still activated.
- ESP® still provides support when you brake.
If ESP® is deactivated and one or more wheels start to spin, the lamp in ESP® warning lamp in the instrument cluster flashes. In such situations, ESP® will not stabilize the vehicle.

•► To deactivate:. The instrument cluster lights up. ESP® OFF warning lamp in the instrument cluster lights up.

WARNING
When the is lit, ESP® OFF warning lamp is lit, ESP® is deactivated.

If the ESP® OFF warning lamp remain lit, ESP® warning lamp and the ESP® is not available due to a malfunction. ESP® OFF warning lamp remain lit, ESP® is not available due to a malfunction.

When ESP® is deactivated or not operational, vehicle stability in standard driving maneuvers is reduced.

Adapt your speed and driving to the prevailing road conditions and to the non-operating status of the ESP®.

Avoid spinning the driven wheels for an extended period with ESP® deactivated.

You could otherwise damage the drivetrain.

•► To activate:.

The the ESP® OFF warning lamp in the instrument cluster goes out.

    See also:

    Center console, lower section
      ...

    Overview
    The on-board computer is activated as soon as you turn the SmartKey to position 1 in the ignition lock. You can control the multifunction display and the settings in the on-board computer using t ...

    Setting the map scale
    To hide the menu: slide the COMAND controller and, when the Full screen menu item is shown, press . To call up the scale bar: as soon as you turn the COMAND controller, scale bar 3 ap ...