Problems with the side windows

Problem: a side window cannot be closed because it is blocked by objects, e.g.

leaves in the window guide.

Close the side window. Remove the objects.
Problem: a side window cannot be closed Close the side window.

Problem: a side window cannot be closed and you cannot see the cause.

WARNING
Closing the side windows with increased force or without the anti-entrapment feature could lead to serious or even fatal injury. Make sure that nobody can become trapped when closing the side windows.

If a side window is obstructed during closing and reopens again slightly:
blocks, pull the corresponding switch again until the side window has closed. Immediately after the window blocks, pull the corresponding switch again until the side window has closed.
The side window is closed with increased force.

If a side window is obstructed again during closing and reopens again slightly:
blocks, pull the corresponding switch again until the side window has closed. Immediately after the window blocks, pull the corresponding switch again until the side window has closed.
The side window is closed without the antientrapment feature.

WARNING
Pulling and holding the switch to close the door window immediately after it had been blocked two times will cause the door window to close without the anti-entrapment feature for as long as you hold the switch.

    See also:

    Adjusting the front-passenger seat from the rear
    WARNING When adjusting the front passenger seat, make sure the seat, if occupied, is as far from the front passenger front air bag as possible. Otherwise, the passenger could be seriously ...

    Belt warning for the driver and front passenger
    Regardless of whether the driver and front passenger have fastened their seat belts already, the seat belt warning lamp lights up for 6 seconds after every engine start. It then goes out if t ...

    Activating the rear view camera
    Make sure that the SmartKey is in position 2 in the ignition lock. Make sure that the "rear view camera" function is selected in COMAND (see the separate operating instructions for C ...