Operating the sliding sunroof

Opening and closing

sunroof after switching off the engine or You can continue to operate the sliding sunroof after switching off the engine or removing the SmartKey from the ignition lock. This function is available for up to five minutes or until the driver's or frontpassenger door is opened.

Overhead control panel

Overhead control panel

1 To raise
2 To open
3 To close/lower

Turn the SmartKey to position 1 or 2 in the ignition lock.
Press or pull the corresponding direction. switch in the corresponding direction.

the If you press the the switch beyond the point of resistance, an automatic opening/ closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.

When opening and raising the roof, automatic operation is only available if the sliding sunroof is in the closed position.

The sun protection cover automatically opens along with the sliding sunroof. You can open or close the sun protection cover manually when the sliding sunroof is raised or closed.

Resetting

Reset the sliding sunroof if it does not move smoothly, or if the battery has been disconnected or has become discharged.

Remove the SmartKey from the ignition lock or select position 0 (KEYLESS-GO).
Remove the fuse for the sliding sunroof from the fuse box. To find out where the fuse is located, refer to the fuse allocation chart in the vehicle tool kit.
Reinsert the fuse.
Turn the SmartKey to position 2 in the ignition lock.
Raise the sliding sunroof fully at the rear.
Keep the second. switch pressed for another second.
Make sure that the sliding sunroof can be fully opened and closed again.
If this is not the case, repeat the steps above again.

opened or closed fully after resetting, If the sliding sunroof still cannot be opened or closed fully after resetting, contact a qualified specialist workshop.

    See also:

    The first 1000 miles (1500 km)
    The more you look after the engine when it is new, the more satisfied you will be with its performance in the future. - Drive at varying vehicle speeds and engine speeds for the first 1000 mile ...

    Cleaning the rear view camera
    Use clear water and a soft cloth to clean camera lens 1. Do not clean the camera lens and the area around the rear view camera with a power washer. ...

    Neutral N with ECO start/stop function activated
    The ECO start/stop function switches the engine off automatically if the vehicle is braked to a standstill when in neutral N and the brake is still depressed. For further information on the ECO ...