Making a call
Entering a telephone number using the telephone keypad
Call up the telephone basic menu.
Enter all the digits of the phone number using the telephone keypad.
To make a call: press the button on the telephone keypad or on the multifunction steering wheel.
Entering a telephone number using the telephone basic menu
Call up the telephone basic menu.
Select the digits one by one by turning and sliding the COMAND controller and press to confirm.
To make a call: select SEND from the telephone basic menu and press to confirm.
or
Press the button on the telephone keypad or on the multifunction steering wheel.
Redialing
Call up the telephone basic menu.
Press the button on the telephone keypad.
or
Select SEND from the telephone basic menu and press to confirm.
In both cases, the calls dialed list appears.
The most recently dialed number is at the top.
To select a call: select an entry by turning the COMAND controller and press to confirm.
The redialing function is also available using the on-board computer.
Calling voicemail
This function is only available if it is supported by the mobile phone network provider.
You can only call voicemail if the voicemail number is stored as preset 1 on the SIM card.
Press and hold the button on the telephone keypad.
or
Use the COMAND controller to select 1 and confirm until dialing commences.
Connecting a call to an entry in a call list or in the COMAND phone book
Open a call list and select an entry.
or
Call up the COMAND phone book and select an entry.
See also:
Limiting the opening angle of thetailgate
Important safety notes
You can limit the opening angle of the tailgate
in the top half of its opening range. This could
be useful, for example, if there is insufficient
space above the tailgate.
...
Storing the current speed or calling upthe last stored speed
WARNING
The set speed stored in memory should only
be set again if prevailing road conditions and
legal speed limits permit. Possible
acceleration or deceleration differences
arising ...
Removing a wheel
– Unscrew the uppermost wheel bolt
completely.
– Screw alignment bolt 1 into the thread
instead of the wheel bolt.
– Unscrew the remaining wheel bolts fully.
Do not place wheel bolts in ...