Resetting the panorama roof with power tilt/sliding panel and the roller sunblinds

Reset the panorama roof with power tilt/ sliding panel and the roller sunblinds if the panorama roof with power tilt/sliding panel or the roller sunblinds do not move smoothly.

•► Turn the SmartKey to position 1 or 2 in the ignition lock.

•► Pull the point switch repeatedly to the point of resistance in the direction of arrow 3 until the panorama roof with power tilt/ sliding panel is fully closed.

•► Keep the additional second. switch pulled for an additional second.

•► Pull the the point switch repeatedly to the point of resistance in the direction of arrow 3 until the roller sunblinds are fully closed.

•► Keep the additional second. switch pulled for an additional second.

•► Make sure that the panorama roof with power tilt/sliding panel and the roller sunblinds can be fully opened again.

•► If this is not the case, repeat the steps above again.

If the panorama roof with power tilt/ sliding panel and the roller sunblind cannot be fully opened or closed after resetting, contact a qualified specialist workshop.

    See also:

    DEF
    Important safety notes For BlueTEC vehicles only. DEF is a non-flammable, non-toxic, colorless, odorless and water-soluble fluid. Only use DEF that complies with ISO 22241. Do not add any ...

    Notes for 4MATIC vehicles
    Vehicles with 4MATIC must not be towed with either the front or the rear axle raised, as doing so will damage the transmission. If the vehicle has transmission damage or damage to the fron ...

    Opening
    Switch off the engine. Remove the SmartKey from the ignition lock. KEYLESS-GO: open the driver’s door. This switches the ignition to position 0, which corresponds to having removed the Sma ...